【LUCK GLASS】Edge Grinding Process Of Float Glass
Publish Time: 2024-08-07 Origin: Site
1. Before going to work, the edge grinding operator must wear protective equipment, gloves and rubber leather. Safety helmet must be worn when grinding large flat glass pieces.
2. Before processing, the size of semi-finished products should be re-examined carefully to avoid the continuation of errors in the upper process, check the appearance quality of glass sheets, and avoid scratches, scales and missing angle that cannot be eliminated by grinding.
3. During inspection, pay attention to whether semi-finished products can be processed. If there are cracks, edge grinding cannot be conducted to avoid injury to equipment and personnel.
4. The sheet glass must be removed from the outside and the inside, not any glass sheets.
Clear Float Glass Sheets
5. High quality flat glass for appearance quality inspection should exceed or be equivalent to the original quality of automobile glass appearance requirements.
6. Grinding amount control: the grinding amount below 8mm is 2.5mm, and the grinding amount between 10-19mm is 1.5mm.Feeding speed: below 8mm, speed of up to 2.5m; between 10 and 19mm, speed of up to 1.5m.
7. After the edge grinding machine is started and shut down every day, operators should carry out routine inspection, including whether the grinding wheel is loose, the degree of wear, and whether the circulating water is clean.
8. Flat glass grinding, layout of more than 3 ㎡, must use the hook and suction cups, people carried the flat glass edge grinding machine can't run, walk pace should agree.
9. To check, to adjust and to correct the grinding wheel every day. The circulating water should be kept clean, and the circulating pipe should be kept unblocked, and the water should be changed frequently.
10. Replacement of grinding wheel can only be processed after cutting.
11. Properly match the grinding amount and feeding speed to avoid glass breakage.
12.To check the appearance size and quality of the float glass after edge grinding. Unqualified products will not flow into the next process.
13. Special shaped edge grinding shall be processed according to the sample or geometric figure strictly according to the requirements of the customer to make the grinding surface smooth and smooth.
14. When grinding, the flat glass must be ground evenly and not too hard, so as not to damage the glass sheets.
15. For the float glass after edge grinding, the paper must be added when the quality glass is stacked with strict requirements.
16, after edge grinding of flat glass stack: when the specification (length * width) do not at the same time, must be in the edge and the edge of the junction of paper isolation (paper about 100 ㎜ * 200 ㎜ or string), to prevent glass scratch.
Amy
—————————————————————
Shahe City Luck Glass Technology Co.,Ltd
Add：1034 Jingguang Road, Shahe City, Hebei Province, China
WhatsApp：+8618713957925